Arizona All Nissan Club

General Discussion => How To / DIY => Topic started by: Blakekat on November 08, 2013, 06:02:16 PM

Title: Trailer brake control
Post by: Blakekat on November 08, 2013, 06:02:16 PM
I have a class 3 hitch factory installed from nissan. I want to start pulling a trailer about 2,000 pound and I wanted to install a trailer brake. I was told the wires already might be run for the trailer brake controller cause the hitch was installed from factory. Anyone know if this is true. Also if this is true anyone know where the connection is. I was thinking I could buy one install it plug and go. Any thoughts?
Title: Re: Trailer brake control
Post by: Hammer (Avi) on November 10, 2013, 02:22:40 AM
Check your harness, if you have the 2nd gen you should have a 7 pin harness that includes trailer brakes.  If the previous owner installed an auto zone or uhaul kit it may only have the lights. 
Title: Re:
Post by: knightrider on November 11, 2013, 12:40:31 AM
I don't think we have a brake controller but there is a small harness you can buy from Nissan to integrate one that plugs in.

Sent from my Galaxy Nexus using Tapatalk