Arizona All Nissan Club

General Discussion => Open Discussions => Topic started by: Jo-BOB on September 06, 2014, 01:36:42 PM

Title: East Valley (Mesa): Xterra Measurements need
Post by: Jo-BOB on September 06, 2014, 01:36:42 PM
Hey guys so I have a group buy set up, and I need to get some measurements for them to get these into production. I live out at 59th ave and 101, and the shop is out in Mesa.

If anyone is able to swing by to get let them get some measurements thatd be awesome. The owner will be there at 9 am on Monday.

and this is their address:
Knuckle Busters
240 E Coury ave
#113
Mesa, 85210

Let me know if anyone is able to do this so I dont have to drive about 45-50 minutes 1 way to get some measurements.
Title: Re: East Valley (Mesa): Xterra Measurements need
Post by: pinchel (Rob) on September 06, 2014, 07:03:25 PM
I would have just posted this in the Group Buy thread. He want 1st gen measurements?!
Title: Re: East Valley (Mesa): Xterra Measurements need
Post by: Jo-BOB on September 06, 2014, 07:13:36 PM
Ya good point, I'll post over there also. I wanted to see if someone even if they werent involved in the group buy would be willing to stop by for some measurements.

and for the 1st gen measurements, if you are in on the group buy he will need to get some measurements from you're rig. As of right now youre the only 1st gen showing interest.
Title: Re: East Valley (Mesa): Xterra Measurements need
Post by: WHPIVxterra on September 06, 2014, 09:57:14 PM
what is the group buy for? I work over at signal butte and elliot so i could swing over on my way to work
Title: Re: East Valley (Mesa): Xterra Measurements need
Post by: Jo-BOB on September 06, 2014, 09:58:46 PM
I posted over in the buy/sell section. But it is for rock sliders. 1st 2nd xterra, and 2nd gen frontiers right now.

check out the for sale section for details.