Arizona All Nissan Club

Club Garage => Xterra Garage => Topic started by: The_Arizonan on April 05, 2017, 01:32:56 PM

Title: Lower control arm
Post by: The_Arizonan on April 05, 2017, 01:32:56 PM
Need new lower control arms. Have a 3" lift what should I go with..???


Sent from my iPhone using Tapatalk
Title: Re: Lower control arm
Post by: pinchel (Rob) on April 05, 2017, 04:44:15 PM
There really aren't much options, but since you are lifted if you have the funds I'd just get the oem recommended part. Their really isn't anything upgraded unless you make your own. I replaced one of mine, only because it broke and it was an off brand.
Title: Re: Lower control arm
Post by: Hammer (Avi) on April 07, 2017, 08:05:04 AM
You can have a weld shop box up the stocks of you're worried about strength.  I've been running stock with a lift for about 5 years now.  I replaced the joints under the recommendation of a mechanic and neither of them were bad. 
Title: Re: Lower control arm
Post by: The_Arizonan on April 07, 2017, 08:47:30 AM
You can have a weld shop box up the stocks of you're worried about strength.  I've been running stock with a lift for about 5 years now.  I replaced the joints under the recommendation of a mechanic and neither of them were bad.




Sent from my iPhone using Tapatalk
Title: Re: Lower control arm
Post by: The_Arizonan on April 07, 2017, 08:48:08 AM
You can have a weld shop box up the stocks of you're worried about strength.  I've been running stock with a lift for about 5 years now.  I replaced the joints under the recommendation of a mechanic and neither of them were bad.

The welds are stressed, just need them welded up


Sent from my iPhone using Tapatalk