General Discussion > How To / DIY

What's in your tool box?

<< < (3/5) > >>

Hammer (Avi):
32mm is the axle shaft, must have.  I must have 2 or 3 of these sets lying around, haven't broken one yet.  http://www.harborfreight.com/13-pc-12-in-drive-metric-impact-deep-wall-socket-set-69279.html

Chuy:

--- Quote from: Thupertrooper (Victor) on August 17, 2016, 11:36:42 AM ---Just depends on how much you want to spend. I got mine through amazon just because i need it overnight delivery thanks to prime.
You can barrow mine no need to buy when you just need it for that. I used mine for the cv axle and nut.

--- End quote ---

Im just not sure what size set and pitch I need.

Thupertrooper (Victor):
If some one wants to copy these


Thupertrooper (Victor):
Good set of small and big snap ring pliers both that open and closes.

pinchel (Rob):

--- Quote from: Thupertrooper (Victor) on August 17, 2016, 08:11:35 PM ---Good set of small and big snap ring pliers both that open and closes.

--- End quote ---

Yup, I needed them when doing the LCA. I bout the universal set from HB.$5

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version