Club Garage > Xterra Garage
Just bought it
Hubcap:
I don't need to go really high just high enough to do 285's if I decide to... I'd like it to sit level more than anything.
DBAX:
I marked off the contact points at full droop w/ PRG UCAs and cut away the issue area. No more droop/contact issues..
Hubcap:
--- Quote from: DBAX on June 05, 2017, 07:35:56 AM ---I marked off the contact points at full droop w/ PRG UCAs and cut away the issue area. No more droop/contact issues..
--- End quote ---
Was this hard to do? Did you use a grinder?
I think this is what i'll do until i can save up my lunch to buy the uca's
Just ordered 2" spacers and aal...got the cam bilts too.
DBAX:
Not hard at all really, just let it drop and mark the line w/ a sharpie then go to work. Yes, a cutting wheel, then grinder to smooth it down. Shot it w/ some black rustoleum and they're good to go. Over 75k miles and no stress or tearing issues in the bucket tops.
Hubcap:
Thanks. I think ill give this a try.
Navigation
[0] Message Index
[*] Previous page
Go to full version