Club Garage > Xterra Garage

What have you done to your AZXC "X" today?

<< < (50/50)

AZGeorge:
Moved the 7-pin trailer connector.  Wiring plan included in case anyone wants to do this also.

ShockBlue_Scott:
Replaced both cam position sensors, and the crankshaft position sensor. When it comes to difficultly the drivers side cam sensor was the easiest of all three to replace, I say this because for the crank sensor you have to remove the wheel/fender liner.

Next on the list of repairs is the timing chain guides and tensioners.

I was really dreading the wheel bearings till I read the post from Rockauto.com the wheel bearings ran from 130-200 at Autozone but before discount from RockAuto they are 75.

Stoic V:
Finally installed the XTP spacer and changed out the plugs. (96k)
 



Navigation

[0] Message Index

[*] Previous page

Go to full version